WAGO SUPPLY FILTER MODULE 750-626 750-613 750-610 750-513 750-600

WAGO SUPPLY FILTER MODULE 750-626 750-613 750-610 750-513 750-600 (USED)

WAGO

750-626 - SUPPLY FILTER

750-613 - SYSTEM POWER SUPPLY 

750-610 - POWER SUPPLY

750-513 (12) - 2-CHANNEL RELAY OUTPUT

750-600 - END MODULE

THE WAGO I/O SYSTEM 750 CAN ALSO BE USED IN MARINE APPLICATIONS AND ONSHORE/OFFSHORE INSTALLATIONS (E.G., PLATFORMS, LOADING FACILITIES). THIS IS POSSIBLE VIA CERTIFICATION UNDER THE STANDARDS OF LEADING AGENCIES SUCH AS GERMANISCHER LLOYD AND LLOYD'S REGISTER. THIS FILTER MODULE ENSURES PROPER (CERTIFIED) SYSTEM OPERATION. THE MODULE FILTERS THE 24 V SYSTEM POWER SUPPLY AND IS EQUIPPED WITH SURGE SUPPRESSION. HIGH-INSULATION VERSIONS ARE STREAMLINED FOR USE IN SYSTEMS WITH INSULATION MONITORING.

THIS INTERNAL SYSTEM SUPPLY MODULE INCREASES THE CAPACITY OF THE SYSTEM SUPPLY BY 2 A FOR FIELDBUS NODES WITH HIGH CURRENT REQUIREMENTS (SUM OF THE INTERNAL CURRENT CONSUMPTION OF THE I/O MODULES).IF REQUIRED, ADDITIONAL SYSTEM SUPPLY MODULES WITH BUS POWER SUPPLY CAN BE USED.THE MODULE ALSO SUPPLIES FIELD-SIDE POWER TO THE ADJACENT MODULES VIA THE POWER JUMPER CONTACTS

THIS SUPPLY MODULE PROVIDES THE I/O MODULES WITH THE CORRESPONDING SUPPLY POTENTIAL.THE MAXIMUM CURRENT PROVIDED BY THE SUPPLY MODULE IS 6.3 A. WHEN CONFIGURING THE SYSTEM, THE TOTAL CURRENT MUST NOT BE EXCEEDED. SHOULD HIGHER CURRENTS BE NECESSARY, AN INTERMEDIATE SUPPLY MODULE MUST BE ADDED TO THE ASSEMBLY.

THIS MODULE IS FUSE-PROTECTED (5 X 20 MM). THE FUSE CAN BE CHANGED QUICKLY, WITH EASE, FROM THE RETRACTABLE FUSE CARRIER.

A BLOWN FUSE AND THE STATUS OF THE SUPPLY VOLTAGE ARE INDICATED VIA LEDS.THE I/O MODULE SENDS INFORMATION ABOUT THE STATUS OF THE SUPPLY MODULE TO THE FIELDBUS COUPLER THROUGH TWO INPUT BITS. ONE BIT IS FOR THE STATUS OF THE FUSE. THE OTHER BIT IS FOR THE STATUS OF THE SUPPLY VOLTAGE

THIS DIGITAL OUTPUT MODULE TRANSMITS CONTROL SIGNALS FROM THE AUTOMATION DEVICE TO THE CONNECTED ACTUATORS.

THE INTERNAL SYSTEM VOLTAGE TRIGGERS THE RELAY.

THE NO CONTACTS ARE ELECTRICALLY ISOLATED.

THE STATE OF THE RELAY IS INDICATED BY A LED.

AFTER THE FIELDBUS NODE IS ASSEMBLED WITH THE CORRECT BUSCOUPLER AND I/O MODULES, THE END MODULE IS SNAPPED ONTO THE ASSEMBLY.

IT COMPLETES THE INTERNAL DATA CIRCUIT AND ENSURES CORRECT DATA FLOW.

REF : FKM6335V1-2